Fujitsu MB88121 SERIES User Manual page 63

CAUTION : DO NOT INTERRUPT OR CUT OFF POWER DURING ERASE !!!
Chip-erase successful
Sending download command
loading and programming...
00148000: Security Address not programmed, use Prog Word!
00148004: Security Address not programmed, use Prog Word!
00148006: Security Address not programmed, use Prog Word!
001448008: Security Address not programmed, use Prog Word!
0014800C: Security Address not programmed, use Prog Word!
0014800E: Security Address not programmed, use Prog Word!
Download and programming completed
Automode finished.
COM port closed
automatically disconnect
Figure 6-2: FME Flash Programmer output message window
As shown in the message window the Security address is not programmed in
Automatic programming process. This is done for security reason to avoid the
activation of the Security function by accident.
8) After successful programming assert Reset or Power-off / On the board in order to
start the programmed application.
© Fujitsu Microelectronics Europe GmbH
SK-91F467-FLEXRAY V1.1
Flash Programming
Note 1:
The MB91F467DA series is checking the serial UART4 interface
for valid string to enter Flash programming mode. For details
about boot sequence refer to Hardware Manual of MB91460
series.
Note 2:
Be aware of Security Features of MB91F467DA series. Check
Documentation of MB91460 series for detailed information!
- 63 - FMEMCU-UG-910017-11