Fujitsu MB88121 SERIES User Manual page 62

Fujitsu switch user guide
Hide thumbs Also See for MB88121 SERIES:
Table of Contents

Advertisement

4) Connect starter kit and PC with a RS232 cable. MB91F467 is using UART4 interface
for serial Flash Programming.
5) Power-off the board or assert and hold RESET
6) Press "Automatic" button to start automatic Flash Programming
Using the "Automatic" button the Programming steps are automatically proceed by
the Flash Programmer Utility.
7) Power-on the board or release RESET to start Flash Programming
After pressing the "Automatic" button release the RESET button or power on the
starter kit in order to start boot Rom execution of MB91F467DA series.
All steps are proceed automatically, download the Flash Programming routine, 'blank
check', Flash erase if necessary and Programming the Application.
Following is displayed in the message window in case of successful programming:
Sending start characters...
Connection OK.
Filesize=8192 (0x2000)
bincommand:
write
writing 8192 bytes...
received checksum = 4426 (0x114A)
calculated checksum = 4426 (0x114A)
OK - checksums match
write finished.
Sending Baudrate Information:
received checksum = 114 (0x0072)
calculated checksum = 114 (0x0072)
OK - checksums match
write byte finished.
Baudrate set (write byte) finished.
calling address 0x030000
bincommand:
"call"
call initiated - waiting for returnvalue...
returnvalue = 254
searching for flash-loader...
Flash mode activated (">" received)
Checking...
Blank Check finished
Chip erase in process...
FMEMCU-UG-910017-11
SK-91F467-FLEXRAY V1.1
Flash Programming
- 62 -
© Fujitsu Microelectronics Europe GmbH

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mb91460 seriesSk-91f467-flexray

Table of Contents