Table of Contents
Advertisement
1.2 Features
•
Supports 32-bit Flash microcontroller MB91F467D
•
Supports FlexRay CC MB88121
•
9-12V (2000mA) unregulated external DC power supply
•
5V, 3.3V, 2.5V and 1.8V on-board switching regulators with power status-LEDs
•
Triple supply monitor to watch 5V, 3.3V and selectable 2.5V or 1.8V
•
On-board Memory:
o 32Mbit (4MByte) SRAM
•
It is possible to connect the FlexRay CC in different ways to the MCU
•
16 bit non multiplexed / multiplexed bus
•
8 bit non multiplexed / multiplexed bus
•
SPI communication
•
All microcontroller resources available for evaluation
•
All microcontroller pins routed to pin header
•
In-Circuit serial Flash programming
•
Three selectable RS-232 or LIN UART-interfaces
•
Three High-Speed CAN interfaces
•
Two FlexRay channels (Ch-A, Ch-B)
•
FlexRay physical layer RS-485 available
•
FlexRay physical layer driver module from TZM (FT1080) connectable
•
16 User LEDs
•
optional: alphanumeric standard LC-Display connectable
•
Reset button, Reset-LED
•
4 User buttons, one 8 bit MCU port can be connected to DIP switches
•
External bus interface routed to 96pin and 48pin DIN 41612 (VG) connectors
This board must only be used for test applications
in an evaluation laboratory environment.
FMEMCU-UG-910017-11
SK-91F467-FLEXRAY V1.1
Introduction
- 8 -
© Fujitsu Microelectronics Europe GmbH
Advertisement
Table of Contents
