Sony XDS-1000 Operation Manual page 81

Item number Item name
743 PR LEVEL (HD)
745 SETUP LEVEL (HD)
746 SYNC PHASE (HD)
747 FINE (HD)
a) Not displayed when the unit is in 23.98P mode.
Item number Item name
802 DIGITAL AUDIO MUTING IN
SHUTTLE MODE
807 AUDIO OUTPUT PHASE
808 INTERNAL AUDIO SIGNAL
GENERATOR
815 AUDIO SAMPLING RATE
CONVERTER
823 NON-AUDIO FLAG PB
Sub-item
1 CH1/CH2
2 CH3/CH4
3 CH5/CH6
4 CH7/CH8
824 ANALOG LINE OUTPUT SELECT
Menu items in the 700s, relating to video control
Settings
Adjust the PR level of the high-definition video signal output from the
HD-SDI OUTPUT or HDMI OUTPUT connectors.
–2048 to 0 to 846
Adjust the setup level of the high-definition video signal output from the
HD-SDI OUTPUT or HDMI OUTPUT connectors.
–272 to 0 to 272
Control the H sync phase of the high-definition video signal output from
the HD-SDI OUTPUT or HDMI OUTPUT connectors.
–128 to 0 to 127
Fine control the H sync phase of the high-definition video signal output
from the HD-SDI OUTPUT or HDMI OUTPUT connectors.
0 to 1023
Menu items in the 800s, relating to audio control
Settings
Set the audio muting conditions during shuttle playback.
off: Not muted.
on: Muted.
Set the output timing of digital audio playback signals (HD-SDI, SDI,
AES/EBU only) as a hexadecimal value, with 80 as a reference position.
Output timing is earlier for values smaller than 80 and later for values
greater than 80. (80, 128 samples = approx. 2.7 ms, 80, 1 sample =
approx. 20 μs)
0 to 80 to FF: Values can be set in this range.
Select the operation of the internal audio test signal generator.
off: Do not output test signal.
silence [silnc]: Silent signal
1kHz sine [1kHz]: 1 kHz, –20 dB FS sine wave signal
When you set the INT SG item on page P1 INPUT of the function menu
to "ON", the internal signal generator operates and outputs simultaneous
test signals to channels 1 to 8 (see page 42).
Select the mode of operation of the sampling rate converter for AES/
EBU input to channels 1 to 8.
off: Do not operate.
on: Operate.
Control non-audio flags in digital audio output.
During playback (except in E-E mode), set non-audio flags in digital
audio output to the following states.
on: Set to on (data is non-audio.)
auto: Set as follows.
• When data is read from media and confirmed: Follow the data.
• When data from media is not confirmed: Maintain current state.
Select the analog audio signals (tracks 1 to 8) to be assigned to audio
output channels 1 and 2.
tr1/2: Tracks 1 and 2 assigned to audio output channels 1 and 2.
tr3/4: Tracks 3 and 4 assigned to audio output channels 1 and 2.
tr5/6: Tracks 5 and 6 assigned to audio output channels 1 and 2.
tr7/8: Tracks 7 and 8 assigned to audio output channels 1 and 2.
81
Setup Menu