Sony SRR1000 Operation Manual page 57

Using salvage to restore files
1
Insert the SRMemory card for which recording did not
end normally into a slot.
A warning message and a message for confirming
whether to perform the salvage or format appear on the
display.
Notes
• If the write-protect switch on the SRMemory card is
set to the "WP" position, slide the switch to the
opposite position.
• The salvage process cannot be stopped once it is
started. Allow plenty of time for the salvage process
to complete.
2
Use the right and left cursor buttons to select
"Salvage" and then press the center cursor button.
The salvage process begins and the "Please wait."
message appears.
The message window will be closed automatically
when the process ends.
Note
Before performing the salvage process, be sure to
remove any other SRMemory cards that may be
inserted.
During the salvage process, the SRMemory card being
processed and all other cards in the unit cannot be
used.
In case files cannot be restored with
salvage process
If the SRMemory card cannot be restored even by
performing a salvage, formatting the SRMemory card will
enable you to use it again.
1
Insert the SRMemory card which the salvage did not
end normally into a slot.
A warning message and a message for confirming
whether to perform the salvage or format appear on the
display.
2
Use the right and left cursor buttons to select "Format"
and then press the center cursor button.
The format process begins and the "Please wait."
message appears.
The message window will be closed automatically
when the process ends.
Notes
• If the ALT/[F9] (REC INHI) buttons in the HOME
menu are set to anything other than Off, change it to
Off.
• During the format process, the SRMemory card
being processed and all other cards in the unit cannot
be used.
57
Troubleshooting