Sony SRR1000 Operation Manual page 47

Button Indication
ALT/[F8] MONITOR
SETTING
[F1] DUAL
[F2]
BORDER
[F3]
BD LEVEL
[F4] BD SLOPE
[F5]
BD POS
[F10] EXIT
ALT/ PORT CONFIG
[F10]
[F2]
SCAN
[F3]
SIZE
[F4]
SIGNAL
[F5] 2D/3D
Setting
Sets the settings for monitor output in 3D mode.
Sets the monitor output for 3D mode.
Link-AB: Outputs each of the LINK-A signal (the signal input from the HD SDI
INPUT A connector) and LINK-B signal (the signal input from the HD SDI
INPUT B connector) in the same way as with main output.
Link-BA: Outputs with LINK-A and LINK-B interchanged in relation to the main
output.
Note
When this item is set to any of the following, the same signal is output for LINK A
output and LINK B output.
Link-A: Outputs the LINK-A signal.
Link-B: Outputs the LINK-B signal.
Splt-AB: Splits the screen into two and outputs the LINK-A signal to the left screen
and the LINK-B signal to the right screen.
Splt-BA: Splits the screen into two and outputs the LINK-B signal to the left screen
and the LINK-A signal to the right screen.
FSq-AB: Outputs the LINK-A signal to the 1st field and the LINK-B signal to the 2nd
field.
FSq-BA: Outputs the LINK-B signal to the 1st field and the LINK-A signal to the 2nd
field.
SxS-AB: Splits the screen into two and then reduces the width of the LINK-A signal
by half and outputs it to left screen and reduces the width of the LINK-B signal
by half and outputs it to the right half.
SxS-BA: Splits the screen into two and then reduces the width of the LINK-B signal
by half and outputs it to left screen and reduces the width of the LINK-A signal
by half and outputs it to the right half.
Selects whether to display a dividing line on the screen when the unit is set to split
the screen into two and output the signals to the monitor during 3D mode.
Off
On
Sets the brightness level of the dividing line on the screen when the unit is set to
split the screen into two and output the signals to the monitor during 3D mode.
1 to 8 to 127
Selects whether the dividing line is sloped on the screen when the unit is set to split
the screen into two and output the signals to the monitor during 3D mode.
Off
On
Sets the position of the dividing line on the screen when the unit is set to split the
screen into two and output the signals to the monitor during 3D mode.
–480 to 0 to 480
Redisplays the previous menu.
Sets the input/output signals of the input/output ports.
Sets the scanning method.
Interlace
PsF
Progres
Sets the resolution.
1280 : 720
1920 : 1080
Sets the sampling rate of video signals.
YPbPr
RGB
Sets 2D/3D operation.
2D
3D
Target
Out
Out
Out
Out
Out
Out
–
I/O
I/O
I/O
I/O
I/O
47
Detailed Menu Description