Adjusting The Output Video Signal - Sony SRR1000 Operation Manual

Adjusting the Output
Video Signal
Setting procedure
Set the output video signal menu items as follows.
1
Press a function selection button (e.g.: [F1]).
The setting value display area lights up.
2
Use the cursor buttons or MULTI CONTROL knob to
change the numerical value.
To set to the preset values
Press the center cursor button or MULTI CONTROL
knob.
The prst (preset) indication appears.
3
Press the function selection button (e.g.: [F1]) for the
desired setting value.
Adjusting the master output level
Use the [F1] (MASTER) button in the VIDEO menu to set
the level.
prst: 100% (4000H)
Numerical value: 0.0 (0H) to 141.3% (5A70H)
Adjustable range: –∞ to +3 dB
Adjusting the Y output level
Use the [F2] (Y) button in the VIDEO menu to set the
level.
prst: 100% (4000H)
Numerical value: 0.0 (0H) to 141.3% (5A70H)
Adjustable range: –∞ to +3 dB
Adjusting the P
B
Use the [F3] (PB) button in the VIDEO menu to set the
level.
prst: 100% (4000H)
Numerical value: 0.0 (0H) to 141.3% (5A70H)
Adjustable range: –∞ to +3 dB
Adjusting the P
R
Use the [F4] (PR) button in the VIDEO menu to set the
level.
prst: 100% (4000H)
Numerical value: 0.0 (0H) to 141.3% (5A70H)
Adjustable range: –∞ to +3 dB
40

Adjusting the Output Video Signal

output level
output level
Adjusting the setup level
Use the [F5] (SETUP) button in the VIDEO menu to set the
level.
prst: 0% (0)
Numerical value: –10.0% to +10.0%
Adjustable range: –10% to +10%
Adjusting the black output level
Use the [F6] (BLK LV) button in the VIDEO menu to set
the level.
prst: 0.0% (110H)
Numerical value: –31.0% (0H) to +31.0% (220H)
Adjustable range: –31.0% to +31.0%
Adjusting the chroma phase output level
Use the [F7] (CRM PH) button in the VIDEO menu to set
the chroma phase.
prst: 0
Value: –127 to +127
Adjustable range: –30° to +30°
Note
In 4:4:4 (RGB 10-bit) mode, adjustment of the output
level, setup level, and chroma phase is disabled.
Adjusting the sync phase
Adjust this when you want to precisely match the output
phase of the unit to the reference signal or when the unit is
used with multiple VTRs and a switcher or other device is
connected and used to create special effects such as fading,
wrapping, and dissolving.
Use the [F8] (SYNC PHASE) button in the VIDEO menu
to adjust the output signal sync phase in relation to the
reference input of the unit.
Press the [F8] button and then press the [F1] (SYNC)
button to roughly adjust the synch phase.
prst: 0 (0)
Numerical value: –128 to +127
Adjustable range: –1.4 to +1.4H
Use the [F2] (FINE) button to finely adjust the sync phase.
prst: 0 (0)
Numerical value: 0 to 1024
Adjustable range: 0 to 323 nsec