Nonlinear Editing - Sony PMW-EX30 Operating Instructions Manual

To record a signal input from an
external device
1
Set the video format to SP 1080/60i
(when "Country" is set to "NTSC
Area") or SP 1080/50i (when
"Country" is set to "PAL Area") on
this unit.
2
Set "i.LINK I/O Select" (see page 89)
of the VIDEO SET menu to "HDV".
Note
Be sure to turn off the power of the
connected devices before changing the
"i.LINK I/O Select" setting.
3
Set the VIDEO INPUT switch to
i.LINK.
4
Start playback on the HVR-M35.
5
Start recording on this unit at the
desired position.
6
When dubbing finishes, stop recording
on this unit and stop playback on the
HVR-M35.
Notes
• An error message is displayed when any
of the following cases occurs. If it does
happen, stop the recording.
- The video format of input signal does
not match that specified on this unit.
- A copy-protected stream is being fed
in.
• If the input to this unit stops during
recording, "z REC" flashes on the
monitor screen, indicating that no i.LINK
signal is being recorded on the SxS
memory card.
When an input signal is resumed,
recording is restarted, incrementing the
clip number on the memory card.

Nonlinear editing

This section shows an example for
connecting a computer with nonlinear
editing software installed via the
DV connector, to edit clips recorded on an
SxS memory card.
For operations of the nonlinear editing software,
refer to the operation manual of the software.
a) i.LINK cable
b) With nonlinear editing software installed.
c) Set "i.LINK I/O Select" (see page 89) of the
VIDEO SET menu to "HDV" or "DVCAM".
Notes
• DVCAM signals cannot be recorded on
this unit.
• Be sure to turn off the power of the
connected devices before switching the
output format (between HDV and
DVCAM).
• The HDV/DV connector of this unit is
a 6-pin connector. Check the number of
pins of the i.LINK connector on your
computer and use an appropriate i.LINK
cable.
Connecting an External Device with the i.LINK Connector
This unit
c)
HDV/DV
a)
b)
Computer
HDV/
77