Ir Remote Commander (Supplied) - Sony PMW-EX30 Operating Instructions Manual

i HD/SD SDI OUTPUT connector
(BNC type)
Outputs HDSDI signals or down-converted
SDSDI signals. Audio signals and timecode
are embedded in the SDI signals. Select the
video format of the output signals with
"HDMI/CMPNT/SDI Out SEL" (see page
87) of the VIDEO SET menu.
Setting "HDMI/CMPNT/SDI Out DISP"
(see page 88) of the VIDEO SET menu to
"On" superimposes the same text
information as that displayed on the LCD
display on the output signals from this
connector.
Note
The output format is fixed to 480i (576i)
when the "i.LINK I/O Select" setting (see
page 89) of the VIDEO SET menu is
"DVCAM".
j HD SDI INPUT connector (BNC
type)
Input HDSDI signals.
Note
When the video format of the input signal
does not match with the video format set on
this unit, recorded and E-E pictures cannot
be displayed. Match the video format of the
input signal with this unit's video format.
k USB connector ( ) (mini-B/USB 2.0)
Connect a computer to access the data of the
SxS memory card loaded on this unit.

IR remote commander (supplied)

When you use the IR remote commander, see "Using
the IR Remote Commander (Supplied)" (page 43).
26 Names and Functions of Parts
l HDV/DV (HDV or DVCAM input/
output) connector (6-pin, IEEE1394,
S400)
Allows input and output of the HDV-format
digital video and audio and output of down-
converted DVCAM signals. Select the
output format with the "i.LINK I/O Select"
setting (see page 89) of the VIDEO SET
menu.
Setting "HDMI/CMPNT/SDI Out DISP"
(see page 88) of the VIDEO SET menu to
"On" superimposes the same text
information as that displayed on the LCD
display on the output signals from this
connector.
Notes
• If the unit is connected to a device
equipped with a 6-pin HDV/DV jack,
when you intend to disconnect or
reconnect the i.LINK cable, turn off the
device and pull out the plug of its power
cord from the AC outlet beforehand. If
you connect or disconnect the i.LINK
cable while the device is connected to the
AC outlet, a high-voltage (8 to 40 V)
current output from the HDV/DV jack of
the device flows into this unit, which may
cause a malfunction to the unit.
• When connecting a device that has a 6-
pin HDV/DV jack to this unit, first plug
the cable into the 6-pin HDV/DV jack of
the device.