Using The Ir Remote Commander (Supplied) - Sony PMW-EX30 Operating Instructions Manual

Using the IR
Remote
Commander
(Supplied)
Before use
Before you use the supplied IR remote
commander for the first time, pull out the
insulation sheet from the battery holder.
A CR2025 lithium battery is set in the
holder at the factory.
To control this unit from the
IR remote commander
You can use the setup menu to enable and
disable the remote control function. The
factory default setting is enable.
To disable the function
Press the MENU button to display the menu
icons. Use the M, m, < or , button to
display the OTHERS menu (
set "IR Remote" to "Off".
The "IR Remote" setting is maintained after
this unit is turned off.
For details on menu operations, see "Basic Menu
Operations" (page 83).
Insulation sheet
), and to
To replace the battery in the
IR remote commander
When the lithium battery's power falls, the
IR remote commander may not work even
if you press the buttons. The average
lithium battery's service life is about one
year, but this depends on the pattern of use.
If pressing the remote control buttons
produces absolutely no effect on the unit,
replace the battery then check the operation
again.
Use a commercially available CR2025
lithium battery. Do not use any battery other
than a CR2025.
1
Hold down the lock lever 1, pull out
the battery holder 2, and remove the
battery.
1
2
Place a new battery in the battery
holder with the + symbol facing
upward 1, then push the battery
holder into the IR remote commander
until it clicks 2.
With the + symbol upward
2
WARNING
Battery may explode if mistreated.
Do not recharge, disassemble, or dispose of
in fire.

Using the IR Remote Commander (Supplied)

2
1
43