Sony PMW-1000 Operation Manual page 49

To copy part of a clip
When you select a single clip and press the arrow
buttons to set an IN and OUT point in the clip, it
becomes possible to copy the section defined by the IN
and OUT points.
On how to set an IN and OUT point, see "To copy the
specified part of a clip" (page 49).
4
Press the COPY button.
The Clip Copy screen appears.
To change the copy source clip
Press the RETURN button to return to the clip list
screen, and then select another clip.
To cancel the copy operation
Press the CANCEL function button (F6) or the RESET
button.
5
Press the SOURCE function button (F1) and select
"SELECTED", "ALL", or "PARTIAL".
To copy the clips selected in step 3: Select
"SELECTED".
To copy all the clips on the SxS memory card:
Select "ALL".
6
Press the START function button (F5).
Copying of the clips starts.
The progress of the copying is shown in the Clip Copy
screen, and the copy icon lights in the status display
area.
To abort the copy operation
Press the ABORT function button (F1), and then press
the YES (F5) button.
The data having already been transferred to the
destination media remains on that media.
If the copy operation is completed successfully, the
message "Copy was successful." appears.
7
Press the OK function button (F5).
The Clip Copy screen disappears, and you return to the
original screen.
To copy an EDL file
An EDL can be copied by an operation similar to a clip
copy operation. However, it is necessary to make a copy of
all clips referenced by the EDL in advance. Therefore,
"ALL" is automatically selected in step 3 of the procedure
for "Copying clips" (page 48).
To copy the specified part of a clip
When you set an IN and OUT point in the clip, it becomes
possible to copy only the part defined by the IN and OUT
points.
1
In the video monitor screen, cue the clip up to the
frame where you want set an IN point.
2
Press the PUSH SET knob while holding down the
B/IN button.
An IN/OUT setting window appears in the bottom
right corner of the display.
The IN point timecode is displayed in the IN/OUT
setting window, and the IN indicator lights.
IN indicator
3
Cue up to the frame where you want to set an OUT
point.
OUT indicator
Copying
49