Sony PMW-1000 Operation Manual page 18

e REMOTE (9P) (remote control 9-pin) connector
(D-sub 9-pin)
Connect a controller that supports the VDCP protocol or
the RS-422A Sony 9-pin VTR control protocol.
f DC IN 12V connector (XLR 4-pin, male)
Connect to a DC power source of 12 V.
When using the BKP-L551 Battery Adaptor to mount a
battery pack, connect the power cable of the BKP-L551.
For details, see "Supplying power" on page 20.
g REMOTE connector (4-pin)
Supplies power to the RM-280 Remote Edit Controller.
h COMPOSITE OUTPUT 1, 2 (SUPER) (analog
composite video output 1, 2 (superimpose))
connectors (BNC type)
Output analog composite video signals. You can
superimpose timecodes, menu settings, or error messages
on the output of the 2 (SUPER) connector when CHAR
SEL on the HOME page of the function menu is set to ON.
See "Basic Operations of the Function Menu" on page 34
for more information about the CHAR SEL setting.
i REF. VIDEO INPUT (reference video signal input)
connectors (BNC type)
The two connectors form a loop-through connection; when
a reference video signal is input to the left connector, the
same signal is input from the right connector (
to a connected device. When no connection is made to the
right connector, the left connector is automatically
terminated with an impedance of 75 ohms.
j
(network) connector (RJ-45 type)
This is a 10BASE-T/100BASE-TX/1000BASE-T
connector for network connection.
CAUTION
• For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port. Follow the instructions for this port.
• When you connect the LAN cable of the unit to
peripheral device, use a shielded-type cable to prevent
malfunction due to radiation noise.
k MAINTENANCE connectors
These are the High Speed USB (USB2.0) connectors for
maintenance.
18
Rear Panel
1 Power supply section
1 POWER switch
a POWER (main power) switch
Press the : side to power on the unit. Press the a side to
power off.
When using the unit, normally leave the POWER switch in
the : (on) position, and use the on/standby button on the
front panel to switch the unit between the operating state
and standby state.
Note
Before turning the main power off, always check to be sure
that the unit is in the standby state, and then press the main
power switch to the a side.
b -AC IN connector
Connect to an AC power source with the power cord (not
supplied).
2 Analog audio signal input/output section
1 ANALOG AUDIO INPUT 1, 2 connectors
) (IN)
ANALOG AUDIO INPUT
1
3 AUDIO MONITOR R, L connectors
a ANALOG AUDIO INPUT 1, 2 connectors (XLR
3-pin, female)
These input analog audio signals.
With A1 INPUT, A2 INPUT, A3 INPUT or A4 INPUT on
page P1 INPUT of the function menu (see page 35), you
can select whether the signal input to connector 1 is
assigned to audio channel 1or 3, and whether the signal
input to connector 2 is assigned to audio channel 2 or 4.
You can set the reference input level with the maintenance
menu. (Factory default setting: +4dB)
For details, refer to the Maintenance Manual.
2 - AC IN connector
2 ANALOG AUDIO OUTPUT 1, 2
connectors
ANALOG AUDIO OUTPUT AUDIO MONITOR
2 1 2 R L