Sony PMW-1000 Operation Manual page 46

Note
Shot marks cannot be set to a locked clip.
Playback in jog mode
In jog mode, you can control the speed of playback by the
speed of turning the jog dial. The playback speed range is
–1 to +1 times normal speed.
To carry out playback in jog mode, proceed as follows.
1
Press the SHTL/JOG button or VAR/JOG button,
turning it on.
2
Turn the jog dial in the desired direction, at the speed
corresponding to the desired playback speed.
Playback in jog mode starts.
The Jog/shuttle transport indicators light as follows.
b (green): Lights during playback in the reverse
direction.
B (green): Lights during playback in the forward
direction.
3
To stop playback in jog mode, stop turning the jog dial.
When setup menu item 101 SELECTION FOR
SEARCH DIAL ENABLE is set to "dial" (factory
default setting), you can start jog playback by simply
rotating the jog dial, even when the SHTL/JOG and
VAR/JOG buttons are not lit.
Playback in shuttle mode
In shuttle mode, you can control the speed of playback by
the angular position of the shuttle dial. The range of
playback speed is ±20 times normal speed or maximum
speed.
To carry out playback in shuttle mode, proceed as follows.
46
Playback
Jog/shuttle transport
indicators
1
Press the SHTL/JOG button, turning it on.
2
Turn the shuttle dial to the desired angle
corresponding to the desired playback speed.
Playback in shuttle mode starts.
The shuttle dial has a detent at the center position, for
still image playback.
The Jog/shuttle transport indicators light as follows.
b (green): Lights during playback in the reverse
direction.
B (green): Lights during playback in the forward
direction.
x (red): Lights during still image display.
3
To stop playback in shuttle mode, return the shuttle
dial to the center position, or press the STOP button.
When setup menu item 101 SELECTION FOR
SEARCH DIAL ENABLE is set to "dial" (factory
default setting), you can start shuttle playback by
simply rotating the shuttle dial, even when the SHTL/
JOG button is not lit.
Notes
• When setup menu item 101 SELECTION FOR
SEARCH DIAL ENABLE is set to "dial", after using the
shuttle dial, return it to the center position. If the shuttle
dial is not in the center position, it is possible
occasionally for vibration from other operations to
activate the dial, and start playback in shuttle mode.
• When you play back a clip without proxy AV data in
shuttle mode, the output video and audio will be
discontinuous.
To alternate between normal-speed playback and
shuttle mode playback
Set the shuttle dial to the position corresponding to the
desired shuttle playback speed, then switch between
normal-speed playback and shuttle playback by pressing
the PLAY and SHTL/JOG buttons alternately.
Jog/shuttle
transport indicators