Saving And Loading Scene Files; Saving Scene Files; Loading Scene Files - Sony PMW-400K Operating Instructions Manual

Saving and Loading
Scene Files
Scene files allow you to save the following types
of data.
• Values set in the PAINT menu
• Shutter speeds set in standard mode or ECS
mode
• White balance data
The data that is saved and loaded depends on the
setting of "FILE" > "Reference" > "Scene
White Data" in the setup menu.

Saving Scene Files

Insert an SxS memory card into a memory card
slot, then proceed as follows.
See "Basic Setup Menu Operations" (page 104) for
information about menu operations.
1
Select "FILE" > "Scene" in the setup
menu.
To assign a name to the data before saving
it
Assign a name before proceeding to step 2.
For details, see "To assign names to files"
(page 154).
2
Select "Scene Store Mem" or "Scene
Store SxS."
Select "Scene Store Mem" if you want to
save the data in the camcorder's internal
memory, and select "Scene Store SxS" if you
want to save the data on an SxS memory
card.
3
Press the MENU knob.
A list box of scene files appears.
File numbers where "No File" is displayed
are empty file numbers
4
Select the file number under which you
want to save the data, and then press the
MENU knob.
A confirmation message appears.
5
To execute the save, select "Execute,"
and then press the MENU knob.
To cancel the save, select "Cancel," and
then press the MENU knob.
If you selected Scene Store SxS in step 2, the
ACCESS lamp lights when you execute the
save (in blue on the right-side panel and in
orange in the card slot section).
When the data has been saved to the SxS
memory card, a completion message appears
and the ACCESS lamp goes out.

Loading Scene Files

Insert an SxS memory card into a memory card
slot, then proceed as follows.
See "Basic Setup Menu Operations" (page 104) for
information about menu operations.
1
Select "FILE" > "Scene" in the setup
menu.
2
Select "Scene Recall Mem" or "Scene
Recall SxS."
Select "Scene Recall Mem" if you want to
load the file from the camcorder's internal
memory, and select "Scene Recall SxS" if
you want to load the file from an SxS
memory card.
3
Press the MENU knob.
A list box of scene files appears. File
numbers where "No File" is displayed are
empty file numbers.
4
Select the desired file number, and then
press the MENU knob.
A confirmation message appears.
5
To execute the load, select "Execute,"
and then press the MENU knob.
To cancel the load, select "Cancel," and
then press the MENU knob.
If you selected "Scene Recall SxS" in step 2,
the ACCESS lamp lights when you execute
the load (in blue on the right-side panel and
in orange in the card slot section).
When the data has been loaded from the SxS
memory card, a completion message appears
and the ACCESS lamp goes out.

Saving and Loading Scene Files

155