Loading Lens Files Automatically - Sony PMW-400K Operating Instructions Manual

Product manual (pmw400 operating instructions)
Hide thumbs Also See for PMW-400K:
Table of Contents

Advertisement

3
To execute the load, select “Execute,”
and then press the MENU knob.
To cancel the load, select “Cancel,” and
then press the MENU knob.
If you select “Execute,” a list box of lens files
appears. File numbers where “No File” is
displayed are empty file numbers.
4
Select the desired file number, and then
press the MENU knob.
A confirmation message appears.
5
To execute the load, select “Execute,”
and then press the MENU knob.
To cancel the load, select “Cancel,” and
then press the MENU knob.
If you selected “Lens Recall SxS” in step 2,
the ACCESS lamp lights when you execute
the load (in blue on the right-side panel and
in orange in the card slot section).
When the specified lens file has been loaded
from the SxS memory card, a completion
message appears and the ACCESS lamp goes
out.

Loading Lens Files Automatically

When you are using a lens that support serial
communication, you can set up the camcorder by
automatically loading the lens file that
corresponds to the lens settings (Lens Auto Recall
function).
To use the Lens Auto Recall function, set “FILE”
> “Lens” > “Lens Auto Recall” in the setup menu
to one of the following.
On: Load the lens file that corresponds to the
model name.
Off: Do not use the Lens Auto Recall function.
Serial Number: Load the lens file that
corresponds to the model name and serial
number (when the lens supports
communication of the serial number).
If the lens does not support communication of the
serial number, both settings load the lens file that
corresponds to the model name.
Page 157

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pmw400kcePmw-400lPmw400lce

Table of Contents