Loading Setting Data; Resetting A File After Changing Its Contents - Sony PMW-400K Operating Instructions Manual
Product manual (pmw400 operating instructions)
Hide thumbs
Also See for PMW-400K:
- Specification sheet (2 pages) ,
- Operating instructions manual (212 pages) ,
- Manual (129 pages)
Table of Contents
Advertisement
Error message
Problem
What to do
NG:Cannot Save No recordable
Insert
media is
recordable
inserted.
media.
NG:Media Full
The media is
Use media with
full.
free capacity
remaining.
To assign names to files
Assigning a name before you save data in an ALL
file can make it easier to distinguish your files.
The following characters can be used in file
names.
Alphanumeric characters (a–z, A–Z, 0–9) and
special characters ( ! # $ % & ' ( ) * + , - . / : ; < =
> ? @ [ \ ] ~)
1
Select “FILE” > “All” > “File ID” in the
setup menu.
2
Turn the MENU knob to select a
character, and then press the MENU
knob.
3
Repeat step 3.
4
When you have finished entering
characters, press the MENU knob to
move the cursor to “SET,” and then
press the MENU knob.
The specified name is displayed.
When you save the file (see page 153), the
data will be saved under this name.
Loading Setting Data
Note
When you load a file from an SxS memory card,
the data saved in the camcorder’s internal
memory is overwritten.
See “Basic Setup Menu Operations” (page 104) for
information about menu operations.
1
Select “FILE” > “All” in the setup
menu.
2
Select “All Load SxS” > “Execute.”
A list box of ALL files appears.
File numbers where “No File” is displayed
are empty file numbers. File numbers with a
file name or a date and time are the number
of files that already contain data.
3
Turn the MENU knob to select the
desired file number.
4
Press the MENU knob.
A confirmation message appears.
5
To execute the load, select “Execute,”
and then press the MENU knob.
To cancel the load, select “Cancel,” and
then press the MENU knob.
If you choose to execute the load, the
ACCESS lamp lights (in blue on the right-
side panel and in orange in the card slot
section). The ACCESS lamp goes out and a
completion message appears when the data
has been loaded from the SxS memory card.
If an error message appears
One of the following error messages may appear
during execution of the load, or as soon as you
select “Execute.” In this case, the file is not
loaded from the SxS memory card.
Error message Problem
What to do
NG:No Data
• There is no
Insert the
readable
media that
media
contains the file
• The specified
you want.
file does not
exist on the
media
Resetting a File after Changing Its
Contents
See “Basic Setup Menu Operations” (page 104) for
information about menu operations.
1
Select “FILE” > “All” in the setup
menu.
2
Select “All Preset,” and then press the
MENU knob.
3
To execute the reset, select “Execute,”
and then press the MENU knob.
To cancel the reset, select “Cancel,” and
then press the MENU knob.
If you choose to execute the reset, all settings
in the ALL file are reset to preset values.
Page 154
Advertisement
Table of Contents
