Sony PMW-400K Operating Instructions Manual page 63

ASSIGN. 1/3 switches, the ASSIGNABLE 4
switch, the COLOR TEMP. button, and the
ASSIGNABLE 5 switch.
• REC START button: the VTR button on the
lens, and buttons and switches to which the
function has been assigned using
"OPERATION" > "Assignable SW" in the
setup menu, including the ASSIGN. 1/3
switches, the ASSIGNABLE 4 switch, the
COLOR TEMP. button, and the ASSIGNABLE
5 switch (when "MAINTENANCE" > "Camera
Config" > "RM Rec Start" in the setup menu is
set to "RM").
To release Remote Control mode
Turn off the camcorder and disconnect the remote
control unit.
The settings on the controls on the camcorder
become valid.
To connect the monitor to the RM-B170/
B750
The MONITOR connector (BNC type) of the
RM-B170/B750 outputs a composite signal. To
connect a monitor to the MONITOR connector on
the RM-B170/B750, use the black cable supplied
with the RM-B170/B750.
Camera image quality adjustment items
when the RM-B170/B750 is connected
When the RM-B170/B750 is connected, the
parameters for camera image quality adjustment
items (paint data) are reset to the parameters that
were specified the last time that RM-B170/B750
was connected.
Function of the recording start/stop
buttons when the RM-B170/B750 is
connected
This setting is made using "MAINTENANCE" >
"Camera Config" > "RM Rec Start" in the setup
menu.
Relationship between the setting of the RM Rec
Start item and the function of recording start/stop
buttons
Recording start/ Settings of RM Rec Start
stop button
RM
Camcorder's REC Disabled Enabled Enabled
START button
Lens' VTR button Disabled Enabled Enabled
Buttons and Disabled Enabled Enabled
switches to which
the recording start/
stop function has
been assigned
(ASSIGN. 1/3
switches,
ASSIGNABLE 4
switch, COLOR
TEMP. button, and
ASSIGNABLE 5
switch)
Remote control Enabled Disabled Enabled
unit's VTR button
Structure of the paint adjustment data
The non-volatile memory of the camcorder used
for storing paint adjustment data consists of two
regions as shown below: one is the "main data
block" that is used when a remote control unit is
not connected, and the other is the "remote
control data block" that is used when a remote
control unit is connected. Paint adjustment data is
automatically selected and output to the camera
section depending on whether or not a remote
control unit such as the RM-B170 is connected.
Operating via the REMOTE Connector
CAM PARA
63