Basic THUMBNAIL Menu
Operations
See “Basic Setup Menu Operations” (page 104) for
information about menu operations.
To display the THUMBNAIL menu
1
Press the THUMBNAIL button to
display the thumbnail screen.
2
Set the MENU ON/OFF switch to ON,
or press the MENU button.
3
Turn the MENU knob to select “TH,”
and then press the knob. Or press the J
or j button to select “TH,” and then
press the SET button.
The THUMBNAIL menu appears.
To hide the THUMBNAIL menu, press the
MENU button again.
To select menu items and sub-items
Do one of the following.
• Turn the MENU knob to select an item or sub-
item, and then press the knob.
• Press the arrow buttons (J, j, K, k) to
select an item or sub-item, and then press the
SET button.
According to the selected item or sub-item, a
selection list or a clip properties screen appears
(see page 98).
To return to the previous state, push the MENU
CANCEL/PRST/ESCAPE switch down to the
ESCAPE side.
Notes
• Some items cannot be operated, when an SxS memory
card is write protected.
• Some items cannot be selected, depending on the state
of the camcorder when the menu was displayed.
To hide the clip properties screen
Do one of the following.
Press the RESET/RETURN button: This
returns to the THUMBNAIL menu.
Press the THUMBNAIL button: The
camcorder enters E-E mode, and the camera
picture appears.