Brbk-Sf1 Hd Optical Multiplex Card (Not Supplied); Brbk-Hsd2 Hd/Sd-Sdi Output Card (Not Supplied) - Sony BRC-H900 Operating Instructions Manual

BRBK-SF1 HD Optical Multiplex
Card (not supplied)
1
BRBK-SF1
R L
AUDIO IN
A AUDIO IN L/R jacks (phono type)
Input an audio signal (stereo), which is output from
the AUDIO OUT jacks on the BRU-SF10 HD
Optical Multiplex Unit via the Optical Fiber Cable.
Note
The audio input on this card accepts audio line
signals only. When you input audio signals from a
microphone, etc., it should be connected with a
microphone amplifier so that audio signals with an
appropriate audio level can be input.
B Optical connector
Performs the optical digital multiplex transmission
of video, audio, external sync and control signals.
A dustproof cap is attached at the factory.
BRBK-HSD2 HD/SD-SDI Output
Card (not supplied)
1 2
MONITOR 1
BRBK-HSD2
SDI OUT
A SDI MONITOR OUT connector (BNC type)
Outputs down-converted SD-SDI signals that
conform to SMPTE 259M serial digital interface
standards, and down-converted HD-SDI signals
that conform to SMPTE 292 serial digital interface
standards.
When the menu display for the camera is turned
ON, the menu display signal that overlaps the
images is output from this connector. When the SD-
SDI output card is installed in the card slot of the
BRU-SF10 HD Optical Multiplex Unit, you can
also hide the menu display by using the DATA MIX
switch on the BRU-SF10. For details, see "Images
when menu display is ON" on page 27.
2
BRU
3
2
OFF
ON
HD SD
B SDI connectors 1, 2 (BNC type)
Outputs down-converted SD-SDI signals that
conform to SMPTE 259M serial digital interface
standards, and down-converted HD-SDI signals
that conform to SMPTE 292 serial digital interface
standards.
When the menu display for the camera is turned
ON, you can select whether to overlap the menu
display with the image by using the C panel
switch. For details, see "Images when menu display
is ON" on page 27.
C Panel switch
Switch between SD-SDI signals and HD-SDI
signals.
When outputting HD-SDI signals, you can select
whether to overlap the menu display with the image
output from SDI connectors 1 and 2. For details, see
"Images when menu display is ON" on page 27.
Notes
• SD-SDI and HD-SDI signals cannot be supplied
simultaneously.
• Set the panel switch before turning on the
camera.
• Do not push the switch forcibly with a
screwdriver, etc.
Images when menu display is ON
When a BRBK-HSD2 is installed in the
BRC-H900 card slot
BRBK-HSD2 MONITOR
panel switch connector
Left position HD/
DATA MIX: ON
(HD-SDI output)
Middle position HD/
DATA MIX: OFF
(HD-SDI output)
Right position SD
(SD-SDI output)
a: Menu is superimposed on image
×: Menu is not superimposed on image
SDI connectors
1, 2
a
a
×
a
Location and Function of Parts
27
GB