Hfbk-Xg1 Xga Interface Board (Not Supplied); Hfbk-Ts1 Hdv Interface Board (Not Supplied); Brbk-H700 Hd Optical Multiplex Card (Not Supplied) - Sony HD 3CCD Operating Instructions Manual

C HD-SDI connector (BNC type)
Supplies HD-SDI signals that conform to the
SMPTE292M serial digital interface standards. The
two connectors output the same signal.
HFBK-XG1 XGA Interface Board
(not supplied)
1
MONITOR
HFBK-XG1
A MONITOR connector (D-sub 15-pin)
Supplies video signals after conversion to VGA,
XGA or WXGA. The standards of output signal
and aspect ratio can be specified in the PC-
OUTPUT menu.
B DIP switches (inside the cap)
When this interface board is inserted into the BRC-
H700 camera or the BRU-H700 HD Optical
Multiplex Unit, the DIP switches cannot be used.
HFBK-TS1 HDV Interface Board
(not supplied)
1
R L
AUDIO
HFBK-TS1
A AUDIO L/R jacks (phono type)
Input audio signals (stereo).
The input audio signals are converted into signals
that comply with HDV standards.
B DIP switches (inside the cap)
When this interface board is inserted into the BRC-
H700 camera or the BRU-H700 HD Optical
Multiplex Unit, the DIP switches cannot be used.
C i.LINK (HDV) OUT connector (i.Link 6-pin)
Supplies video and audio signals after they are
converted to comply with HDV standards.
26
Location and Function of Parts
2
2 3
i.LINK ( HDV ) OUT
Note
The audio input on this board accepts audio line signals
only. When you input audio signals from a microphone,
etc., it should be connected with a microphone amplifier
so that audio signals with an appropriate audio level can
be input.
BRBK-H700 HD Optical Multiplex
Card (not supplied)
1
BRBK-H700
R L
AUDIO IN
A AUDIO IN L/R jacks (phono type)
Input an audio signal (stereo) that is output from the
AUDIO OUT jacks on the BRBK-H700 HD
Optical Multiplex Unit via the Optical Fiber Cable.
Note
The audio input on this board accepts audio line
signals only. When you input audio signals from a
microphone, etc., it should be connected with a
microphone amplifier so that audio signals with an
appropriate audio level can be input.
B Optical connector
Performs the optical digital multiplex transmission
of video, audio, external sync and control signals.
A dustproof cap is attached at the factory.
2
BRU-H700