Sony BRC-H900 Operating Instructions Manual page 26

K EXT SYNC OUT connector
Supplies external video sync signals input from the
EXT SYNC IN connector.
When a cable is connected to this connector, the
75-ohm termination for inputs is automatically
opened, and signals input to the EXT SYNC IN
connector are output from this connector.
L
RGB/COMPONENT connector
Supplies the images from the camera as a YPbPr or
RGB signal.
M VISCA RS-232C IN connector
Connect to the RM-BR300 Remote Control Unit
(not supplied). When you connect multiple
cameras, connect it to the VISCA RS-232C OUT
connector of the previous camera in a daisy-chain
connection.
N VISCA RS-232C OUT connector
When you connect multiple cameras, connect it to
the VISCA RS-232C IN connector of the next
camera in a daisy-chain connection.
Caution
When you connect the RS-232C connecting cable
of the unit to a peripheral device, use the supplied
cable to prevent malfunction due to radiation noise.
O VISCA RS-422 connector
Connect to the VISCA RS-422 connector of the
camera or another BRC-H900 HD Optical
Multiplex Unit.
For the connection to the VISCA RS-422
connector, see "Using the VISCA RS-422
Connector Plug" on page 89.
P AUDIO OUT L/R jacks
Loop through output of the audio line signal input
from the AUDIO IN jacks on the BRBK-SF1 HD
Optical Multiplex Card inserted into the camera via
the Optical Fiber Cable.
Q VISCA FUNCTION switches
These switches are used for the VISCA
communication settings.
Switch 1 (RS-232C/RS-422 selector)
Set to ON for RS-422, or OFF for RS-232C.
Switch 2 (Communication baud rate
selector)
Set to ON for 38,400 bps, or OFF for 9,600 bps.
26
GB
Location and Function of Parts
Switches 3 to 5 (Camera address selectors)
Set the address of the camera.
Normally set to "0". With this setting, addresses are
assigned to the cameras automatically in the
connected order by pressing the POWER button
while holding down the RESET button on the
RM-BR300 Remote Control Unit (not supplied).
You can assign the camera address "1" to "7'
manually by setting these selectors as follows:
Camera 0 1
address
Switch 3 OFF ON OFF ON OFF ON OFF ON
Switch 4 OFF OFF ON ON OFF OFF ON ON
Switch 5 OFF OFF OFF OFF ON ON ON ON
Note
Cameras with addresses assigned by setting the
switches to "0" and cameras with addresses
assigned to "1" to "7" cannot be used together. In
addition, the same address cannot be assigned to
multiple cameras.
Switch 6 (59.94/50 signal format selector)
Set to ON for output of 50 signal format, or OFF for
output of 59.94 signal format.
The 1080i and 720p formats are automatically
applied to this unit based on the BOTTOM switch
setting of the camera.
Be sure to configure the same setting on this unit
and the camera.
Switches 7 to 10: Not used. Set them to OFF.
Note
Set the switches before you turn on the power of the
unit.
R DC 12 V connector
Connect to the supplied AC adaptor.
S Card slot
Install BRBK-SA1 or BRBK-HSD2 optional
interface card here.
The slot cover is attached to the unit at the factory.
2 3 4 5 6 7