Sony BRC-H900 Operating Instructions Manual page 19

K Remote sensor
This is the sensor for the supplied Remote
Commander.
This remote sensor does not function when IMG
FLIP is set to ON in the SYSTEM menu.
L HD/SD select switch
Outputs an SD-SDI signal from the SDI connector
when the switch is set to SD, or an HD-SDI signal
from the SDI connector when the switch is set to
HD.
Note
Set the switch before turning the camera on.
M
RGB/COMPONENT connector
Supplies the images as an analog component
(YPbPr or RGB) signal.
N VISCA RS-232C IN connector
Connect to the RM-BR300 Remote Control Unit
(not supplied). When you connect multiple
cameras, connect it to the VISCA RS-232C OUT
connector of the previous camera in a daisy-chain
connection.
O VISCA RS-232C OUT connector
When you connect multiple cameras, connect it to
the VISCA RS-232C IN connector of the next
camera in a daisy-chain connection.
P EXT SYNC IN connector
Accepts external video sync signals.
Q T VIDEO connector
Outputs the camera images as a composite video
signal.
R
S VIDEO connector
Outputs the camera images as an S video signal.
S SDI connector
Outputs the video signal from the camera as an HD/
SD-SDI signal.
Supplies down-converted SD-SDI signals that
conform to the SMPTE 259M serial digital
interface standards, or HD-SDI signals that
conform to the SMPTE 292 serial digital interface
standards. Select HD-SDI or SD-SDI signals with
the HD/SD select switch.
T Card slot
Insert the optional card, such as BRBK-HSD2,
BRBK-SA1, BRBK-SF1, etc.
The slot cover is attached to the camera at the
factory.
U DC IN 12V connector
Connect the supplied AC power adaptor.
Bottom
ws
V Ceiling bracket mounting screw holes
When you install the camera to the ceiling or on a
shelf, etc., in a high position, secure the supplied
ceiling bracket to these holes using the supplied
four screws. The four feet are attached to the holes
at the factory.
For installation, see "Installing the Camera in a
High Position" on page 56.
W Tripod screw holes (1/4-20UNC)
When you install the camera to a tripod, secure the
tripod to these holes.
X BOTTOM switches
Used for the output signal format selection, RS-
232C/RS-422 selection, baud rate selection, remote
control signal output on/off and camera address
setting.
For details, see "Setting of the BOTTOM switches"
on page 19.
Setting of the BOTTOM switches
1 O
N
2
3
4
O
1
N
2
3
4
wd wf
1
2
3
4
5
Location and Function of Parts
19
GB