Appendix; List Of Messages - Sony BRC-H900 Operating Instructions Manual

Appendix

List of Messages

The following messages may appear on the screen. Take
the necessary measures shown below.
Indicators on the BRC-H900 camera
Indicator
STANDBY lamp
flashes.
The back tally lamp
flashes.
Messages for the BRC-H900 camera
Message
Please restart
system!
PRESET xx OK
(xx = preset position
numbers 01 to 16)
One Push WB...OK
(NG)
FAN STOP!
(The message will
flash in the main
menu.)
CAUTION
COOLING FAN
STOPPED!
PRESET (xx) OUT
OF RANGE (xx =
preset position
numbers 01 to 16)
72
GB
List of Messages
Meaning/remedies
The camera stopped moving due to an
error in the pan/tilt mechanism. Reset
the pan/tilt position or turn off the power
of the camera, then turn it on again.
Turn off the power of the camera, then
consult your Sony dealer.
Meaning/remedies
You are prompted to restart the power of
the camera after you changed the setting
of "IMG FLIP" in the SYSTEM menu.
Use the POWER button on the supplied
Remote Commander or the POWER
button on the RM-BR300 Remote
Control Unit to turn the power off, then
on. The changed setting becomes
effective.
When you store the camera settings into
the memory (POSITION 1-16), the
message will appear for two seconds.
While the white balance is automatically
adjusted, the message will appear. Wait
for a while. When the adjustment is
complete, it will disappear.
Turn off the power of the camera, then
consult your Sony dealer.
Turn off the power of the camera, then
consult your Sony dealer.
This message appears when you preset
the camera position when the pan/tilt
position of the camera is out of range of
the current PAN-TILT LIMIT setting.
This camera position presetting will fail.
Perform the presetting again after
moving the camera within the range of
the PAN-TILT LIMIT setting.
Messages for video outputs from the BRU-SF10
HD Optical Multiplex Unit
Message Meaning/remedies
Communication • The AC adaptor is not properly
error connected to the DC IN 12V
Please check connector on the BRC-H900, or the
connection AC cord may be disconnected from
the power outlet. Check that the
BRC-H900 is turned on.
• The CCFC-S200 Optical Fiber Cable
connecting the BRC-H900 to the
BRU-SF10 is connected improperly,
or the optical fiber cable may be
damaged.
• Image frequency settings for the
BRC-H900 and the BRU-SF10 may
be different. For details on settings,
see page 20 and 26. After checking
the above conditions, restart the
BRC-H900 and BRU-SF10.
Option card error This message appears when an
Please check option unsupported optional interface card is
card inserted in the card slot of the
BRU-SF10. Remove the card after
turning off the BRU-SF10.