Zooming; Operating Multiple Cameras With The Remote Commander - Sony BRC-H900 Operating Instructions Manual

Arrow button Movement of the
camera
Note
The setting above only changes the signal emitted from
the Remote Commander, and does not change the setting
of the camera itself. Therefore, repeat the setting for
each Remote Commander if you are using more than
one Remote Commander.
If the STANDBY lamp of the camera
flashes
When the camera is moved or turned by hand or by
external shock, the microcomputer inside the camera
may not be able to memorize the pan/tilt position
properly and the camera may stop.
To reset the pan/tilt position, press the PAN-TILT
RESET button or turn the power of the camera off, then
turn it on again.
STANDBY flashes

Zooming

Setting
Press either of the ZOOM buttons.
L/R
DIRECTION SET
While holding down
STD
1
Press.
L/R
DIRECTION SET
While holding down
REV
Note
2
When you perform pan/tilt operation while the camera is
Press.
in the telephoto mode, the moving speed of the image on
the screen may be a little jerky.
Operating Multiple Cameras with
the Remote Commander
1
2
You can then operate the camera(s) specified by number.
Every time you operate the camera(s) using the Remote
Commander, the CAMERA SELECT button pressed in
step 2 lights.
SLOW ZOOM FAST
T T
Subject appears
farther away. W W
(Wide angle) L/R
DIRECTION SET
RM-EV100
Zooms in or out
slowly
(SLOW side)
Set the IR SELECT switch on the rear of the camera
you want to operate to 1, 2 or 3.
1 2 3
IR SELECT
Press the CAMERA SELECT button on the
Remote Commander that corresponds to the
number set in step 1.
POWER
CAMERA SELECT
1 2
FOCUS
AUTO
FAR NEAR
DATA SCREEN BACK LIGHT
PAN-TILT
RESET
Subject appears
closer.
(Telephoto)
Zooms in or
out quickly
(FAST side)
CAMERA
3
SELECT
MANUAL
45
Pan/Tilt and Zoom Operation
GB