Automatic Sending Status; Stop Sending Automatic Status; Color/Grey Scale Graphic; Enable Saving Data - Fujitsu FTP604 User Manual

3.8.29 Automatic sending status

[Name]
[Format]
[Description]

3.8.30 Stop sending automatic status

[Name]
[Format]
[Description]

3.8.31 Color/Grey scale graphic

[Name]
[Format]
[Description]

3.8.32 Enable saving data

[Name]
[Format]
12-02-2003
Page 3-27 of
51
If n > 1 and < 254 then the output will
be turned on in n/4.096msec, and then
turned off again.
If n = 255, then the output will be turned
on.
Automatic sending status
ASCII ESC a
Hex 1B 61
Decimal 27 97
When this command is sent once, then the
board will transmit the status every time that
it change state.
Stop sending automatic status
ASCII ESC b
Hex 1B 62
Decimal 27 98
When this command is sent then it will turn
off transmitting status.
Colour / Grey scale graphic
ASCII ESC c
Hex 1B 63
Decimal 27 99
When this command is sent then will the
board not feed. After the next graphic data
(both compression and not). The n is a
percent of the burn ratio, n can be from 0 to
15, and the burn ratio is 100/15*n. This
command is used by the driver to make
colour and grey scales printout.
Enable saving data
ASCII ESC d
Hex 1B 64
- 3-27 -
n
n
n