Irda Connector; Aux Input Connector - Fujitsu FTP604 User Manual

6.1.5 IRDA connector

IRDA connector CN7: B4B-ZR
Mating connector part number:
TBA
Pin
Function

6.1.6 AUX INPUT connector

Connector type CN6: 53324-0710
Mating connector part number:
Housing:
Contact: TBA
CN4:
Pin
1
2
3
7
The paper near end status, can be seen on the LED on the aux
connector, it can be reading through the status command, and if a
driver is used, then it can be reading in the port monitor: If paper jam is
used, then will the printer stop printing if this signal is going low, the
value of this bit can be seen on the LED on the aux output connector, it
can be reading by a status request, or if a driver is used, then it can be
reading by the port monitor
The paper near end and paper jam is indicated on LED at the AUX
connector CN4. The status of these bits can also be read with a
response on a status request. If a driver is used, then the status can
also be read in the print monitor. If paper jam sensor is activated
printing will stop until paper jam sensor is deactivated. The LED will
show these conditions.
12-02-2003
Page 6-37 of
51
1
+5V
TBA
Function
LED1+
INPUT1
GND
GND
2 3
TX RX
Pin Function
4
5
6
- 6-37 -
4
GND
LED2+
INPUT2
GND