Save Data To Board; Change Dot Size; Change Form Feed Length; Change Baud Rate - Fujitsu FTP604 User Manual

[Description]

3.8.33 Save data to board

[Name]
[Format]
[Description]

3.8.34 Change dot size

[Name]
[Format]
[Description]

3.8.35 Change form feed length

[Name]
[Format]
[Description]

3.8.36 Change baud rate

[Name]
[Format]
12-02-2003
Page 3-28 of
51
Decimal 27 100
This command will enable that the boards
save values to the flash, this is made to
ensure that a wrong transmission not will
change settings in the board, remember to
send the command "Saving data to board",
to actual save the data.
Save data to board
ASCII ESC e
Hex 1B 65
Decimal 27 101
This command saves all settings to flash.
Change dot size
ASCII ESC f
Hex 1B 66
Decimal 27 102 n
If n = 0x01, then the board is set to
FTP624MCLxxx.
If n = 0x02 then is it set to FTP634MCLxxx.
The value is saved to flash,
Change form feed length
ASCII ESC g
Hex 1B 67
Decimal 27 103 n
N represents the value in mm that is form
feeded after the feed command is sent. The
value is saved to flash.
Change baud rate
ASCII ESC h
Hex 1B 68
- 3-28 -
n
n
n
n
n
n