Installing Drivers And Utility; Automatic Installation - Fujitsu PRIMERGY PG-FC202 User Manual

4

Installing Drivers and Utility

This chapter explains the procedure for installing drivers and utility.
Before installing drivers (including adding a card), disconnect the cable from the
Fibre Channel Controller, and then logon using administrator privileges.
When the Fibre Channel Controller is additionally installed, it is necessary to update
the installed Fibre Channel Controller at the same time. All the Fibre Channel
Controllers are targets for driver updates regardless of Product ID.
• For installing drivers and utility (HBAnyware) at the same time.
"4.1 Automatic Installation"(pg.53)
• For installing drivers and utility (HBAnyware) manually.
"4.2 Manual Installation"(pg.55)
4.1

Automatic Installation

The following shows the procedures for installing drivers and HBAnyware, using "AutoPilot
Installer" that enables automatic installation.
If [Welcome to the Found New Hardware Wizard] appears during startup, click [Cancel].
1
Insert the driver disk (CD-ROM) into the CD-ROM drive.
2
Execute the next program in the driver disk.
• For Windows Server 2003
Storportminiportkit_1-30a9-1e.exe
• For Windows 2000 Server
ScsiPortMiniportKit_5-31a0-1e.exe
3
Click [Next].
4
Click [Install].
When the next window appears, click [OK].
• For Windows Server 2003
Storport Miniport Driver kit 1.30a9-1e
• For Windows 2000 Server
SCSIport Miniport Driver kit 5.31a0-1e
5
Confirm that [Start AutoPilot Installer] is checked, and then click
[Finish].
"AutoPilot Installer" starts.
4 Installing Drivers and Utility
E
53