Command; Commands - Fujitsu M3099EX/EH Oem Manual

M3099EX/EH OEM Manual

Command

Commands sent from the host computer to the scanner are as listed
in Table 3.6. The scanner commands are as follows:
Table 3.6 Commands
Command Command Details
name code
CLEAR 44 This command initializes the scanner.
This command can be issued at any time.
CONTROL 58 This command sets the operation mode of
the scanner and the operation mode in the
main window.
IMAGE 5A This command sets the image processing
CONTROL mode of the scanner. (*1)
PRINT 5E This command instructs how to print to the
CONTROL manuscript. (*2)
START 53 This command reports the size of a
document to be read.
READ 54 This command starts reading. The scanner
starts reading according to the operation
mode set previously.
SENSE 41 This command requests a status report.
RETURN 42 This command requests a status report on
SENSE the return of the flatbed read.
IMAGE 43 This command requests a status report of
MODE the image processing mode of each main
SENSE window and the number of pixels (in units
of a byte) per line in the X- direction.
SEND 46 This command transfers the dither and
DITHER 1 overlay patterns.
SEND 47 This command transfers the dither, curve,
DITHER 2 or overlay patterns.
SEND DATA 48 Transfers print pattern and data items. (*2)
INQUIRY 40 This command requests a device
information report.
*1: This command can be transmitted only when the image processing
option is connected.
*2: This command can be transmitted only when the endorser option is
connected.
INTERFACE
SPECIFICATIONS
3-17