A2.6 How To Test The Printing By The Operator Panel Operation - Fujitsu M3099EX/EH Oem Manual

<< SETUP MODE >>
No-Mode 1
RESET Finish !!
<< CE MODE >>
TEST
A-4
A2.5 How to reset the print head life counter
You must reset the print head life counter, when you replace the print head.
INK RESET
Screen 12
INK RESET
Yes-Mode 2
Screen 13
Screen 14

A2.6 How to test the printing by the operator panel operation

You can check the print result by the following procedures.
: START
Screen 15
NOTICE: The scanner prints the five digit numbers from the initial
number by the increment of one.
NOTICE: Before pressing [START], you can set document size,
resolution and so on. (See OPERATOR'S GUIDE)
13 At Screen 1 press [Mode 1] eleven times to
go to INK RESET screen. (Screen 12)
14 Press [Mode 2] to see Screen 13.
If you want to reset the counter, press [Mode
2]. And you can see Screen 14 for 3 sec.
If you don't want it, press [Mode 1] to go to
Screen 12.
If you want to close the job, go to 7 .
15 Set the endorser ON by the procedure of the
section A2.1.
16 While pressing the [Mode 2], turn the power
of the scanner on. Then the LCD displays the
MAINTENANCE MODE initial screen.
(Screen 15)
17 Press [Mode 2] once and press [Mode 1]
once. Place the document on the stacker.
Then press [START].
M3099EX/EH OEM Manual