Pick Roller Replacement - Fujitsu M3099EX/EH Oem Manual

Pick Roller
Replacement
M3099EX/EH OEM Manual
Replace the pick roller as follows:
Upper transport unit
Operator panel
Power switch
Lever
Pick roller
U shaped clip
Pick roller
section
White mark
1 Turn off the power switch.
2 Open the upper transport
unit. (See page 4-2)
3 Put off U shaped clips on
both ends of the pick roller
shaft. Pull the pick rollers
outward each other to
remove.
4 Install a new pick rollers
and put the U shaped clips
on the pick roller shaft.
5 Close the upper transport
unit. (See page 4-2)
NOTICE
When you install pick rollers,
make sure that the white
marks on the side of the both
pick rollers be in the right-
hand side of the scanner.
BASIC
OPERATION
4-35