Dell PowerConnect W-Airwave Configuration Manual page 84

Perform these steps to configure a
1. Click
this type.
2. Click the
edit that profile. The
Table 20 Aruba Configuration > Profiles > AP > System Profile Settings
Field
General Settings
Folder
Name
Other Settings
LMS IP
Backup LMS IP
LMS Preemption
LMS Hold-down
Period (1-3600 sec)
Master Controller IP
Address
LED Operating
Mode
RF Band
Double Encrypt
Native VLAN ID
(0-4094)
SAP MTU
84 | Aruba Configuration Reference
Profiles > AP > System
in the
Add
button to create a new
Details
page appears. Complete the settings as described in
Default
Top
Blank
N/A
N/A
No
600
N/A
normal
g
No
1
N/A
System
profile.
Aruba Navigation
pane. This page summarizes the current profiles of
System
profile, or click the
Description
Use this field to set and display the folder with which the profile is
associated. The drop-down menu displays all folders available for
association with the profile.
Folders provide a way to organize the visibility of device parameters that is
separate from the configuration groups of devices. Using folders, you can
view basic statistics about device, and define which users have visibility to
which device parameters.
Enter the name of the profile.
Enter an IP address.
For those APs that need to boot off the local controller, configure the LMS
IP address to point to the new local controller.
Enter the IP address of the backup LMS controller.
The AP fallback feature allows an AP associated with the backup controller
(backup LMS) to fail back to the primary controller (primary LMS) if it
becomes available. Enable LMS preemption with this field.
Enter the amount of time the remote AP must wait before moving back to
the primary controller.
Enter the IP address of the master controller.
Specify the LED operating mode for AP-12X controllers. Options are
normal and off.
Indicates the band for mesh operation for multiband radios. Select a or g.
Important: If you create more than one mesh cluster profile for an AP or
AP group, each mesh cluster profile must use the same band.
The double encryption feature applies only for traffic to and from a wireless
client that is connected to a tunneled SSID. When this feature is enabled,
all traffic (which is already encrypted using Layer-2 encryption) is re-
encrypted in the IPSec tunnel. When this feature is disabled, the wireless
frame is only encapsulated inside the IPSec tunnel. All other types of data
traffic between the controller and the AP (wired traffic and traffic from a
split-tunneled SSID) are always encrypted in the IPSec tunnel.
Enter the ID of the native VLAN. The supported range is from 0 to 4094.
Specify the Service Access Point (SAP) maximum transmission unit (MTU)
in bytes. The range is 1024 to 1578 bytes.
AirWave Wireless Management Suite | Configuration Guide
pencil
icon next to an existing profile to
Table 20: