Profiles > Mesh > Cluster; Profiles > Qos - Dell PowerConnect W-Airwave Configuration Manual

Profiles > Mesh > Cluster
AirWave provides a "default" version of the mesh cluster profile. You can use the "default" version or create
a new instance of a profile which you can then edit as you need. You can configure a maximum of 16 mesh
cluster profiles on a mesh node.
Perform these steps to create or edit Mesh Cluster profiles.
1. Click
2. Click the
Details
The
Table 39 Aruba Configuration > Profiles > Mesh > Cluster Profile Settings
Field
General Settings
Folder
Name
Other Settings
Cluster Name
RF Band
Encryption
3. Click
Profiles > QoS
The following QoS profiles configure traffic management and VoIP functions.
Traffic Management—Specifies the minimum percentage of available bandwidth to be allocated to a
specific SSID when there is congestion on the wireless network, and sets the interval between
bandwidth usage reports. Refer to
VoIP Call Admission Control—Aruba's Voice Call Admission Control limits the number of active
voice calls per AP by load-balancing or ignoring excess call requests. This profile enables active load
balancing and call admission controls, and sets limits for the numbers of simultaneous Session Initiated
Protocol (SIP), SpectraLink Voice Priority (SVP), Cisco Skinny Client Control Protocol (SCCP), Vocera
or New Office Environment (NOE) calls that can be handled by a single radio. Refer to
VoIP Call Admission Control" on
AirWave Wireless Management Suite | Configuration Guide
Profiles > Mesh > Cluster
Add
button to create a new
page appears. Complete the settings as described in
Default Description
Top Use this field to set and display the folder with which the profile is associated.
The drop-down menu displays all folders available for association with the profile.
Folders provide a way to organize the visibility of device parameters that is
separate from the configuration groups of devices. Using folders, you can view
basic statistics about device, and define which users have visibility to which
device parameters.
Blank Enter the name of the profile.
aruba-mesh Enter the mesh cluster name. The name can have a maximum of 32 characters,
which is used as the MSSID. When you create a new cluster profile, it is a
member of the "Aruba-mesh" cluster.
NOTE: Each mesh cluster profile should have a unique MSSID. Configure a new
MSSID before you apply the mesh cluster profile.
To view existing mesh cluster profiles, use the command: show ap mesh-cluster-
profile. A mesh portal chooses the best cluster profile and provisions it for use. A
mesh point can have a maximum of 16 cluster profiles
a Use this setting to indicate the band for mesh operation for multiband radios.
Select a or g.
Important: If you create more than one mesh cluster profile for an AP or AP
group, each mesh cluster profile must use the same band
Open System Use this setting to configure the data encryption, which can be either open
system (no authentication or h) or WPA2-PSK-AES (WPA2 with AES encryption
using a preshared key).
AirWave recommends selecting WPA2-PSK-AES and entering a passphrase (see
WPA Passphrase). Keep the passphrase in a safe place.
Add Save
or . The added or edited
Aruba Navigation
in the pane.
Cluster ,
profile or click the
Cluster
profile appears on the
"Profiles > QoS > Traffic Management" on
page 112.
pencil
icon to edit an existing profile.
Table 30:
Profiles > Mesh > Cluster
page 112.
"Profiles > QoS >
Aruba Configuration Reference |
page.
111