Brocade Communications Systems PowerConnect B-RX Release Note page 28

Software image
installed on
BigIron RX
02.5.00
02.5.00a
02.5.00b
02.5.00c
02.5.00d
02.5.00e
02.5.00f
02.5.00g
02.5.00h
02.5.00i
02.5.00j
02.6.00
02.6.00a
02.6.00b
02.6.00c
02.6.00d
02.6.00e
02.7.00
02.7.01
02.7.01a
02.7.01b
02.7.02
02.7.02a
To upgrade the MBRIDGE FPGA image on a BigIron RX management module, you must perform the
following general steps:
Determine the versions of the images currently installed on the BigIron RX management module
1.
using the show version command.
Place the new MBRIDGE FPGA image on a TFTP server to which the BigIron RX system has
1.
access or on a PCMCIA flash card inserted in slot 1 or 2.
Copy the MBRIDGE FPGA image from the TFTP server or a flash card in slot 1 or 2 to all
2.
management modules or a management module in a specified chassis slot. To perform this step,
enter one of the following commands at the Privileged EXEC level of the CLI (example: BigIron
RX#):
copy tftp mbridge <TFTP-server-ip-addr> <image-name> MBRIDGE
•
copy slot1 | slot2 mbridge <image-name> MBRIDGE
•
After the MBRIDGE upgrade is complete, the management module must be reloaded.
3.
Verify that the MBRIDGE image(s) have been successfully copied to the specified interface
4.
module(s) by entering the following command at any level of the CLI:
show version
•
Check for the MBRIDGE image version numbers in the output. See MBRIDGE.
IronWare Software Release 02.7.02a for Brocade BigIron RX Series Swtches
Release Notes v 1.0
FPGA
image
SBRIDGE
SBRIDGE
SBRIDGE
SBRIDGE
SBRIDGE
SBRIDGE
SBRIDGE
SBRIDGE
SBRIDGE
SBRIDGE
SBRIDGE
SBRIDGE
SBRIDGE
SBRIDGE
SBRIDGE
SBRIDGE
SBRIDGE
SBRIDGE
SBRIDGE
SBRIDGE
SBRIDGE
SBRIDGE
SBRIDGE
Compatible FPGA
version
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
6
Page 28 of 46