Table of Contents
Advertisement
Code flash and boot flash information
This field...
Management Modules
<type> Management Module
(<location>)
Code Flash
IronWare Image (Primary or
Secondary)
LP Kernel Image (Monitor for LP
Image Type 0)
IronWare Software Release 02.7.02a for Brocade BigIron RX Series Swtches
Release Notes v 1.0
Displays...
The management module for which flash information is displayed.
The <type> parameter indicates an active or standby management
module.
The <location> parameter indicates the top or bottom slot (M1 or M2,
respectively).
The model number and size of the management module's code flash.
Indicates the IronWare image installed in the primary or secondary
location in the management module's code flash. The actual image name
depends on the version of software you have running on your BigIron RX.
The output displays the following information about the image:
Version – "2.2.1Txxy" indicates the image version number.
The "Txxy" is used by Brocade for record keeping. The "xx"
indicates the hardware type, while the "y" indicates the image
type.
Size – The size, in bytes, of the image.
Check sum – A unique ID for the image. If the contents of the
image change, the check sum changes also.
Compilation date and time – The date and time that Brocade
compiled the image.
Indicates the interface modules Boot-Monitor image stored in the
management module's code flash. The management module stores
these images only; it does not run the images. The output displays the
following information about the image:
Version – "2.2.1Txxy" indicates the image version number.
The "Txxy" is used by Brocade for record keeping. The "xx"
indicates the hardware type, while the "y" indicates the image
type.
Size – The size, in bytes, of the image.
Check sum – A unique ID for the image. If the contents of the
image change, the check sum changes also.
Compilation date and time – The date and time that Brocade
compiled the image.
Page 15 of 46
Advertisement
Table of Contents
