Table of Contents
Advertisement
To install an additional hot-swap power supply, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Press the blue release latch on the power-supply filler and pull the handle to the
3. If the handle is not already in the open position, press the orange release latch
4. Slide the power supply into the bay and fully close the locking handle by sliding
5. Connect one end of the power cord for the new power supply into the ac
6. Make sure that the ac power LED on the power supply is lit, indicating that the
Installing a hot-swap hard disk drive
The following notes describe the types of hard disk drives that the server supports
and other information that you must consider when you install a hard disk drive:
v The server supports up to eight 1-inch (26 mm) slim-high, 2.5-inch, hot-swap
v Start installing the hard disk drives from the bottom bay (bay 0).
v For a list of supported optional devices for the server, see http://www.ibm.com/
v If the server will be configured for RAID operation, see the documentation that
v All hot-swap drives in the server should have the same throughput speed rating;
v To minimize the possibility of damage to the hard disk drives when you install the
v You do not have to turn off the server to install hot-swap drives in the hot-swap
on page 32.
open position. Then, remove the filler from power-supply bay 2.
on the power-supply handle to the right and lift the handle up to the open
position.
it down to the locked position.
connector on the back of the power supply, and connect the other end of the
power cord into a properly grounded electrical outlet.
power supply is operating correctly. If the server is turned on, make sure that
the dc power LED on the top of the power supply is lit also.
hard disk drives in the standard hot-swap bays.
servers/eserver/serverproven/compat/us/.
comes with the controller for instructions for installing a hard disk drive.
using drives with different speed ratings might cause all drives to operate at the
lowest throughput speed.
server in a rack configuration, install the server in the rack before you install the
hard disk drives.
drive bays. However, you must turn off the server when you perform any steps
that involve installing or removing cables.
Chapter 2. Installing optional devices
47
Advertisement
Table of Contents
