Table of Contents
Advertisement
6. Route the power cord through the power cord retention clip so that it does not
7. Connect the power cord for the new power supply to the power-cord connector
8. Connect the other end of the power cord to a properly grounded electrical
9. Make sure that the ac power LED and the dc power LED on the power supply
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the MAX5 installation."
Completing the MAX5 installation
To complete the MAX5 expansion module installation, complete the following steps:
1. Reinstall the system-board tray (see "Replacing the MAX5 system-board tray.").
2. Reinstall the MAX5 bezel (see "Replacing the MAX5 bezel" on page 82).
3. Reconnect the cables and power cords (see "Connecting the MAX5 cables" on
4. Slide the MAX5 and the server back into the rack, if necessary.
5. Turn on the peripheral devices and the host server
Replacing the MAX5 system-board tray
To replace the system-board tray, complete the following step:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Grasp the system-board tray on both sides (near the stop-tabs) and align the
accidentally become disconnected.
on the power supply.
outlet.
are lit, indicating that the power supply is operating correctly. The two green
LEDs are to the right of the power-cord connector.
page 82).
on page 32.
system-board tray with the chassis.
Chapter 2. Installing optional devices
81
Advertisement
Table of Contents
