Intel BX80580Q9400 - Core 2 Quad 2.66 GHz Processor User Manual page 25

Getting Started
12.
13.
14.
15.
16.
17.
18.
The system is now ready for normal operation.
Development Kit User's Manual
From DOS, Run the following to reprogram the MAC address:
a) eeupdate /nic=1 /mac=xxxxxxxxxxxx (xxxxxxxxxxxx is the MAC
Address from the sticker)
b) Make sure there are no warnings or errors
From DOS, Run the following to update the Keyboard and System
Controller flash:
a) kscupdate ksc.bin
b) Make sure there are no warnings or errors
Power the system down by pressing the PWR button
Clear the CMOS by performing the following:
a) Shunt the CMOS CLR jumper (J5H2 – near the on-board battery)
b) Press the PWR button on the board. The board will not power on, but
a couple of LEDs will flash.
c) Switch the power supply off to power down the board
d) Remove the CMOS CLR jumper (J5H2).
Unplug the bootable USB Key
Verify Correct BIOS Installation
a) Switch the power supply back on
b) Press the PWR button on the board to power-up the system
c) Boot to BIOS Configuration screen by pressing F2 at the BIOS splash
screen.
d) In the BIOS Main screen, check that the "Project Version" lists the
correct version of the BIOS.
e) Press the PWR key on the board to power the system back down.
Re-connect the SATA data cable from the hard drive to the development
board at connector J6J3.
§
25