Commands Available During Execution Of User Program - Fujitsu SOFTUNE User Manual

CHAPTER2 Dependence Functions
2.2.3

Commands Available during Execution of User Program

This section explains the commands available during the execution of a user program.
■ Commands Available during Execution of User Program
The emulator debugger (MB2197) allows you to use certain commands during the execution of a user
program.
For more details, refer to "■ Supported Debuggers" in "SOFTUNE Workbench Command Reference
Manual".
The double circle indicates that it is available during the execution of a user program.
Table 2.2-1 shows the commands available during the execution of a user program.
Table 2.2-1 Commands Available during Execution of User Program
MCU reset
Memory operation (Read/Write)
Line assembly, Disassembly
Notes:
• The conditions which allow you to use the commands in Table 2.2-1 are limited to the following
cases when a user program is executed.
- [Debug] - [Run] - [Go] menu
- [Go] button on the debug toolbar
The commands in Table 2.2-1 cannot be used when the GO command is entered in the command
window.
• An error message appears if you enter a command that cannot be used during the execution of a
user program.
"E4404S Command error (MCU is busy)."
72
Function Limitations and
Restrictions
- 1.3 RESET
5.1 EXAMINE
5.2 ENTER
5.3 SET MEMORY
5.4 SHOW MEMORY
- 5.5 SEARCH MEMORY
5.8 COMPARE
5.9 FILL
5.10 MOVE
5.11 DUMP
6.1 ASSEMBLE
-
6.2 DISASSEMBLE
Major Commands