Dell 5210n Mono Laser Printer User Manual page 63

Security
This menu selection is used to set security levels on individual print jobs requiring a PIN.
Menu selection: Purpose:
Job Expiration Limits the amount of time a confidential job stays in the printer before it is deleted.
Network/Ports
TCP/IP
This menu section is use to view and change the Transmission Control Protocol/Internet Protocol settings.
NOTE: This menu is not displayed for non-network models.
Menu selection: Purpose:
TCP/IP Sets the network option to TCP/IP (Transmission Control Protocol/Internet Protocol)
Standard Network and Network <x>
Use this menu selection to change printer settings affecting jobs sent to the printer through a network port (either Standard Network or Network <x>).
Menu Purpose:
selection:
PCL Configures the printer so it automatically
SmartSwitch switches to PCL emulation when a print job
received through the network port requires it,
regardless of the default printer language.
PS Configures the printer so it automatically
SmartSwitch switches to PostScript emulation when a print
job received through the network port requires
it, regardless of the default printer language.
NPA Mode Specifies whether the printer performs the
special processing required for bidirectional
communication, following the conventions
defined in the Network Printing Alliance
(NPA) Protocol.
NOTE: Changing this menu item automatically
resets the printer.
Network Configures the size of the network input buffer.
Buffer
Values:
On* Printer examines data on the network interface and selects PCL
emulation if the data indicates that is the required printer language.
Off Printer does not examine the incoming data. The printer uses
PostScript emulation to process the job if PS SmartSwitch is On, or
uses the default printer language specified in the
SmartSwitch is Off.
On* Printer examines data on the network interface connection and
selects PostScript emulation if the data indicates that is the required
printer language.
Off Printer does not examine the incoming data. The printer uses PCL
emulation to process the job if PCL SmartSwitch is On, or uses the
default printer language specified in the
SmartSwitch is Off.
Off Printer does not perform NPA processing.
Auto* Printer examines the data to determine the format and then
processes it appropriately.
Auto* Printer automatically calculates the Network Buffer size
(recommended setting).
Values:
Off*
1 hour
4 hours
24 hours
1 week
Values:
Activate On*
Off
View Hostname View only
Address 4 field IP address
Netmask
Gateway
Enable DHCP On*
Off
Enable RARP
Enable BOOTP
AutoIP
Enable FTP/TFTP
HTTP Server Enabled
WINS Server Address 4 field IP address
DNS Server Address
Setup Menu
Setup Menu if PCL
if PS