Custom Types; Universal Setup; Bin Setup - Dell 5210n Mono Laser Printer User Manual

single-sided job.
Vinyl Labels
Loading
Bond Loading
Letterhead
Loading
Preprinted
Loading
Colored Loading
Card Stock Properly handles preprinted card stock whether the job is a duplexed or
Loading single-sided job.
Custom <x> Properly handles preprinted custom paper whether the job is a duplexed
Loading or single-sided job.

Custom Types

This menu selection is used to define a name for each custom paper type. You can assign names from the operator panel.
Menu Purpose:
selection:
Custom Specifies the type of paper associated with each Custom
Type N Type available in the Paper Type menu.

Universal Setup

This menu selection is used to specify the height and width of the Universal Paper Size. By specifying the height and width for Universal Paper Size, the
printer will use the Universal setting exactly like other paper sizes, including support for duplex and n-up.
Menu Purpose:
selection:
Units of Determines the unit of measure used to enter the
Measure Universal Height and Width.
Portrait Sets the portrait width of the universal media.
Width
NOTE: If the value set exceeds the maximum width,
the printer will use the maximum value allowed in
inches or millimeters.
Portrait Sets the portrait height of the universal media.
Height
NOTE: If the value set exceeds the maximum height,
the printer will use the maximum value allowed in
inches or millimeters.
Feed Specifies the feed direction of the Universal Paper
Direction Size.

Bin Setup

This menu selection is used to specify the output bin where you want your printed material to go to.
NOTE: Bin Setup is only displayed when at least one optional output bin is installed.
Menu Purpose:
selection:
Output Bin Specifies the default bin for printed material.
Configure Determines which output bin(s) the printer uses for a particular
Bins job.
Off*
Duplex Shown if Card Stock is supported in the specified
Off* input source.
Duplex Shown if the custom type is supported in the
Off* specified input source.
Values:
Paper* The custom type media must be supported in the input source you
Card Stock designate in order to assign a user-defined name.
Transparency
Labels
Once the name is assigned, the name (truncated to 16 characters)
Vinyl Labels
will be displayed instead of Custom Type x.
Envelope
Values:
Inches Inches is US default; Millimeters is international default.
Millimeters
3 inches to 14.17 inches Shows either inches or millimeters from Units of Measure
in 0.01 inch increments setting; 8.5 inches is the US default, and 216 mm is the
international default.
(76 mm to 360 mm in 1
mm increments)
3 inches to 14.17 inches Shows either inches or millimeters from Units of Measure
in 0.01 inch increments setting; 14 inches is the US default, 356 mm is the
international default.
(76 mm to 360 mm in 1
mm increments)
Short Edge* Long Edge is only shown if the longest edge is shorter
Long Edge than the Maximum Physical Width of the printer.
Values:
Standard Bin*
Bin <x>
Mailbox Sends print jobs to the output bin designated for that
user.
Link* Links two or more bins together as though they were
one large bin. When one linked bin is full, the printer
starts filling the next linked bin, and continues with each
additional linked bin.
Mail Overflow Sends print jobs to the output bin designated for that
If a user-defined name is available, it appears
l
instead of Bin <x>.
The name is truncated to 14 characters.
l
If two or more bins share the same name, the
l
name only appears once in the Output Bin value
list.