Print Fonts; Setup Menu - Dell 5210n Mono Laser Printer User Manual

Print Fonts

This menu selection prints a list of the fonts stored in the printer.
Menu Purpose:
selection:
Print Fonts Prints a sample of all the fonts available for the selected printer
language.
Settings

Setup Menu

Use this menu selection to configure a variety of printer features.
Menu Purpose:
selection:
Display Determines the language of the text
Language displayed on the operator panel.
Power Specifies the amount of time (in minutes)
Saver the printer waits after a job is printed
before it goes into a reduced power state.
Alarms Controls whether the printer sounds an
alarm when the printer requires operator
intervention.
Timeouts Specifies the amount of time (in seconds)
the printer waits to return to the home
screen, receive an end-of-job message, or
receive additional bytes of data from the
computer.
NOTE: Wait Timeout is only available
when you use PostScript emulation. This
menu value has no effect on PCL emulation
print jobs.
Values:
PCL
Fonts
PS Fonts
Values:
English NOTE: All values may not be available.
Français
Deutsch
Italiano
Español
Dansk
Norsk
Nederlands
Svenska
Português
Suomi
Russian
Polski
Hungarian
Turkish
Czech
Simplified
Chinese
Traditional
Chinese
Korean
Japanese
Disabled This value does not appear unless Energy Conserve is set to Off.
1...240 Specifies the amount of time after a print job before the printer goes into Power
Saver mode. (Your printer may not support the entire range of values.)
The factory default Power Saver setting depends on your printer model. Print the
menu settings page to determine the current Power Saver setting. When the
printer is in Power Saver mode, it is still ready to receive print jobs.
Select 1 to put the printer in Power Saver mode one minute after it finishes a print
job. This uses much less energy, but requires more warm-up time for the printer.
Select 1 if your printer shares an electrical circuit with room lighting and you notice
lights flickering.
Select a high value if your printer is in constant use. Under most circumstances, this
keeps the printer ready to print with minimum warm-up time. Select a value
between 1 and 240 minutes if you want a balance between energy consumption
and a shorter warm-up period.
Alarm Off — Printer does not sound an alarm.
Control:
Off
Single* — Printer sounds three quick beeps.
Single*
Continuous
Continuous — Printer repeats three beeps every 10 seconds.
Toner Alarm:
Off*
Single
Continuous
Screen Disabled — Disables Screen Timeout.
Timeout:
15–300 (30*)
15–300 — Specifies the amount of time the printer waits before returning to the
home screen.
30* is the default setting.
Print Disabled — Disables Print Timeout.
Timeout:
Disabled
1–255 — Specifies the amount of time the printer waits for an end-of-job message
1–255 (90*)
before canceling the remainder of the print job.
Prints a sample of all printer fonts available for PCL
emulation.
Prints a sample of all printer fonts available for PostScript
emulation.