Calibrating The Built-In Gyrosensor - Pioneer AVIC-505 Owner's Manual

A message confirming registration of your password is displayed. The system also reads back
your password.
• Your password should be 6 to 23 characters long.
• See "The Text Palette" on page 38 for instructions on using the text palette.
• If you don't want to use a password, enter the single character "*". Then move ahead to "Calibrating
the built-in gyrosensor" below.
• If you enter "*", you may change your mind and register a password later by choosing "PASSWORD"
from the Settings menu. When asked for the current password, enter "*"(see page 113).
The password is registered and the Destination menu is displayed.
• If you wish to hear the pronunciation again, select "REPEAT" instead. If the pronunciation is
incorrect, select "NO" and the text palette will appear once again for you to enter a new password. Be
sure to input a different password which is easy to pronounce.
• You can change your password at any time (see "Password" on page 113).
• Use one of the memo pages at the end of this manual to note down the password, then remove the
page and keep it in a safe place. Do not keep a note of your password in the vehicle.
• If you choose to register a password, you will have to enter your password every time the Navigation
System is turned on. Enter the password as you did above or say your password.