Dell W5300 Workgroup Laser Printer User Manual page 23

You can also assign an IP address using: BOOTP, or a RARP server and telnet, or static ARP entry and telnet.
Use BOOTP
BOOTP (Bootstrap Protocol) is an internet standard protocol that lets users on a local area network find their
IP address. The BOOTP server, or a forwarding agent, must be attached to the same IP subnet as the new
printer.
The BOOTP method works like this: First, the printer broadcasts its presence on the network. The BOOTP
server hears the broadcast and recognizes the printer hardware address. The BOOTP server replies, setting
the IP address, netmask, and gateway in the printer. To set the IP parameters using BOOTP:
1. Determine the hardware address of the printer. This is a 12-digit alphanumeric listed as UAA on the
network setup page. Use the number in the right column.
2. Configure the BOOTP server. Edit the BOOTP configuration file (normally /etc/bootptab). This file is a
collection of entries for each BOOTP client served by this server.
An entry for a particular hardware address sets various IP parameters. The following is an example of
a typical entry:
net_printer:\
ht=ether:\
ha=000400123ABC:\
ip=192.168.2.0:\
sm=255.255.255.128:\
gw=192.168.0.0:\
hn:
Parameter
net_printer=
ht=ether
ha=00400123ABC
ip=192.168.2.0
sm=255.255.255.0
gw=192.168.0.0
3. Make sure BOOTP is enabled. Check the network setup page.
4. Set up the printer host name in the computer. To do so, define the printer IP name and address in the
/etc/hosts file or on the name server. This address must match the IP address. You may want to use a
host name that is meaningful in your environment (for example, a name that identifies the printer
location).
Use dynamic RARP server and telnet
Description
Host name
Hardware type (Ethernet)
Hardware address
IP address
Netmask
Gateway