Insufficient Defrag Memory; Memory Full; Complex Page; Insufficient Memory - Dell W5300 Workgroup Laser Printer User Manual

37 Insufficient
Defrag Memory
37 Insufficient
Memory

38 Memory Full

39 Complex Page

The printer cannot defragment
flash memory, because the
printer memory used to store
undeleted flash resources is full.
The printer memory is full and
cannot continue processing
current print jobs.
The printer is processing data, but
the memory used to store pages
is full.
The page may not print correctly
because the print information on
the page is too complex.
Delete fonts, macros, and other data
in printer memory.
Install additional printer memory.
Press Go to clear the message and
continue the current print job. The
printer frees memory by deleting the
oldest held job and continues
deleting held jobs until there is
enough printer memory to process
the job.
Press Stop to clear the message
without deleting any held jobs. The
current job may not print correctly.
Press Menu to open the Job Menu
and cancel the current job.
To avoid this error in the future:
Delete fonts, macros, and
other data in printer memory.
Install additional printer
memory.
NOTE: The messages 37 Insufficient
Memory and Held Jobs may be lost
alternate on the display.
See also: Accessing held jobs from the
operator panel; Held Jobs may be lost
Press Go to clear the message and
continue printing the job. The job
may not print correctly.
Press Menu to open the Job Menu
and cancel the current job.
To avoid this error in the future:
Simplify the print job by
reducing the amount of text or
graphics on a page and
deleting unnecessary
downloaded fonts or macros.
Install additional printer
memory.
See also: Canceling a print job
Press Go to clear the message and
continue printing the job. The job
may not print correctly.
Press Menu to open the Job Menu
and cancel the current job.
To avoid this error in the future:
Reduce the complexity of the
page by reducing the amount
of text or graphics on the page
and deleting unnecessary
downloaded fonts or macros.
Set Page Protect to On in the