Instant Access Point View; Figure 97 Instant Access Point View - Dell PowerConnect W-IAP175P User Manual

Table 14
Graph Name Description
Throughput

Instant Access Point View

All IAPs in the Dell Instant network are listed in the Access Points tab. Click the IAP that you want to monitor.
Access Point view for that IAP appears.
Similar to the Virtual Controller view, the Access Point view also has three tabs: Networks, Access Points, and
Clients.
The following sections in the Instant UI provide information about the selected IAP:
Info

RF Dashboard

RF Trends

Usage Trends

Figure 97
122 | Monitoring
Network View - Graphs and Monitoring Procedures (Continued)
The Throughput graph shows the throughput of the
selected network for the last 15 minutes.
 Outgoing traffic - Throughput for outgoing traffic
is displayed in green. Outgoing traffic is shown
above the median line.
 Incoming traffic - Throughput for incoming traffic
is displayed in blue. Incoming traffic is shown
below the median line.
To see an enlarged view, click the graph.
 The enlarged view provides Last, Minimum,
Maximum, and Average statistics for the incoming
and outgoing traffic throughput of the network for
the last 15 minutes.
To see the exact throughput of the selected network
at a particular time, hover the cursor over the graph
line.
Instant Access Point View
Monitoring Procedure
To check the throughput of the selected network for
the last 15 minutes,
1. Log in to the Instant UI. The Virtual Controller view
appears. This is the default view.
2. In the Networks tab, click the network for which
you want to check the client association. The
Network view appears.
3. Study the Throughput graph in the Usage Trends
pane. For example, the graph on the left shows
22.0 kbps incoming traffic throughput for the
selected network at 12:03 hours.
Dell PowerConnect W-Instant Access Point 5.0.3.0-1.1.0.0 | User Guide