Creating Role Assignment Rules; Figure 73 Creating A New User Role - Dell PowerConnect W-IAP175P User Manual

Figure 73
7. Click OK. The Allow any to all destinations access rule is enabled by default. This rule allows traffic to all
destinations. To create new access rules, see
8. To delete a user role, select the user role and click the Delete button.

Creating Role Assignment Rules

To create role assignment rules for the user role, perform the following steps:
1. Click New button in the Role Assignment Rules table. The default user role is the newly created user role.
2. Select the attribute from the Attribute drop-down list. To view the list of supported attributes, see
supported VSA's" on
3. Select the operator from the Operator drop-down list. The following types of operators are supported:
contains - To check if the attribute contains the operand value.

Is the role - To check if the role is same as the operand value.

equals - To check if the attribute is equal to the operand value.

not-equals - To check if the attribute is not equal to the operand value.

starts-with - To check if the attribute the starts with the operand value.

ends-with - To check if the attribute ends with the operand value.

4. Enter the string to match the String text box.
5. Select the appropriate role from the Role drop-down list.
6. Click OK.
86 | Role Derivation
Creating a New User Role
page 72.
"Example Access Rules" on
Dell PowerConnect W-Instant Access Point 5.0.3.0-1.1.0.0 | User Guide
page 93.
"List of