Figure 30 Adding A Voice Network - Basic Info Tab; Table 7 Conditions For Adding A Voice Network - Basic Info Tab - Dell PowerConnect W-IAP175P User Manual

Figure 30
In the Basic Info tab, perform the following steps:
a. Type a name for the network in the Name (SSID) text box.
b. Select the Voice radio button from the Primary usage options. This selection determines the primary
usage of the network being added.
c. Select the required Client IP assignment option. Available options for a Voice network are Network
assigned - Default, Network assigned - VLAN ID, and Virtual Controller assigned.
Table 7
If
You select the Network assigned – Default option
You select the Network assigned – VLAN ID option
You select Virtual Controller assigned option
2. Click the More link and perform the following steps (These steps are optional).
a. Band - Set the band at which the wireless network will transmit radio signals. Available options are All, 2.4
GHz, and 5 GHz. The All option is selected by default. It is also the recommended option.
b. Hide SSID - Select this check box if you want to hide the SSID (network name) from the users.
42 | Wireless Network
Adding a Voice Network - Basic Info Tab
Conditions for Adding a Voice Network - Basic Info Tab
then,
The client gets the IP address in the same subnet at the IAPs.
The client gets the IP address from the specified VLAN. Enter
the ID of the VLAN in the VLAN ID text box.
The client gets the IP address from the virtual controller. The
virtual controller creates a private subnet and VLAN for the
IAPs and the wireless clients. The virtual controller NATs all
traffic that passes out of this interface. This setup eliminates
the need for complex VLAN and IP address management for a
multi-site wireless network.
Dell PowerConnect W-Instant Access Point 5.0.3.0-1.1.0.0 | User Guide