Management Authentication Settings; Figure - Dell PowerConnect W-IAP175P User Manual

Prompt

Rad-Authenticator

Rad-Code

Rad-Id

Rad-Length

Reply-Message

Revoke-Text

Server-Group

Server-Name

Service-Type

Session-Timeout

Simultaneous-Use

State

Strip-User-Name

Suffix

Termination-Action

Termination-Menu

Tunnel-Assignment-Id

Tunnel-Client-Auth-Id

Tunnel-Client-Endpoint

Tunnel-Connection-Id

Tunnel-Medium-Type

Tunnel-Preference

Tunnel-Private-Group-Id

Tunnel-Server-Auth-Id

Tunnel-Server-Endpoint

Tunnel-Type

User-Category

User-Name

User-VLAN

Vendor-Specific


Management Authentication Settings

To authenticate the Virtual Controller Management UI, perform the following steps:
1. Click the Settings link.
2. Select the Admin tab.
3. In the Authentication drop-down list, select any one of the following:
Internal - Select the Username and Password specified in the respective text boxes to access the Virtual

Controller Management UI.
RADIUS Server - Specify one or two radius servers to authenticate UI. If two servers are configured users can

use them in primary/backup mode or load-balancing mode, this is identical to the radius server configuration
for SSIDs. For information on configuring external RADIUS server, see
page 70.
74 | Authentication Dell PowerConnect W-Instant Access Point 5.0.3.0-1.1.0.0 | User Guide
"External RADIUS Server" on