Setup > Track - Navman TRACKFISH 6500 Installation And Operation Manual

2 The display shows fuel flow and RPM for the
two engines. Identify which line has data
for the port engine; for example vary the
speed of one engine or have one engine
running and the other stopped.
3 Press or to select the line with data
for the port engine. Press
to select Port and press
4 Repeat steps 2 and 3 for the starboard
engine.
5 Press when done.
Speed source
17-6 Setup > Track
Press one or more times until the
Setup menu is displayed, then select Track:
Tracking records and displays the boat's course
on the chart (see section 3-5). Five different
tracks can be recorded: track 1 has up to 2000
points and tracks 2, 3, 4 and 5 have up to 500
points each.
Record
Off: The TRACKFISH stops recording a
track.
1 to 5 (select a track number): The
TRACKFISH starts recording the boat's
course into the selected track.
Display
Off: No track is shown on the chart.
1 to 5 (select a track number): The
selected track is shown on the chart.
64
If both paddlewheel sensor and GPS speeds are
available, select the source of speed readings
for fuel calculations. If there is a current or tide,
these speeds and the fuel calculation results
will be different.
. Press
.
Plotting Interval
Select the plotting and recording interval. The
options are Distance or Time.
Distance
Select the distance plotting interval: 0.01, 0.05,
0.1, 0.5, 1.0, 2.0, 5.0 or 10.0 distance units.
Time
Select the time plotting interval: 1, 5, 10 or 30
seconds or 1 minute.
Memory used
The percentage of memory used in the track
being recorded.
number of points recorded in each track
(see section 14).
Send track
This option is included for compatibility with
older units. For information, see your NAVMAN
dealer.
Delete track
The data in the track selected for Record (see
above) is deleted.
NAVMAN
Water speed: Use paddlewheel sensor
speed (boat speed through the water). This
gives a more accurate value for Economy.
GPS: Use GPS speed (boat speed relative to
land). This gives a more accurate value for
Range.
Tip: Use the user card display to check the
TRACKFISH 6500 Installation and Operation Manual